Gocator 2400 Series

TAKE MICRON-LEVEL MEASUREMENTS

Measure micron level features with the 2400’s 2 megapixel camera and large field of view. Scan parts for even the smallest defects and achieve superior results for 3D quality inspection.

INSPECT WITH SPEED AND PRECISION

Faster scan and acquisition speeds empower you to speed up your inline process and use higher resolutions. It also means multiple exposures can be used to accurately measure high-contrast targets. With an X resolution down to 6 µm, you can generate data points even on very tiny edges or narrow gaps.

EASY TO SET UP AND USE

Gocator’s built-in GUI allows for flexible configuration of settings and measurement tools using any web browser, computer or operating system. With no additional software to install, Gocator’s out-of-the-box setup and configuration is fast and easy.

Gocator 2400 series sensors are designed for 100% inspection of challenging targets, such as micro-features on small electronic parts, and dark materials such as tire tread/sidewall and rubber sheets in high-speed inline applications.

• 2-Megapixel imager. Up to 1940 points per profile resolution
• Field-of-view (FOV) up to 2000 mm
• Measurement range up to 1525 mm

When starting a new 3D vision project, In-Position Technologies engineers start by reviewing the key requirements to determine the optimum 3D sensor for the job. They perform all necessary engineering calculations to make sure the vision system performs as required, within customer specification, and without unnecessary cost. They will also recommend the appropriate cables, fixturing, and add-on accessories to make system installation as smooth as possible.

This includes:

• Determine what measurements will be required
• Ensuring field of view and scan precision is adequate
• Calculating needed scan rate for desired throughput
• Verifying mounting compatibility, form factor checks, etc…
• Ensuring all necessary accessories are also specified

When ordering Gocator 2400 Series 3D smart sensors as a part of a full system, IP Tech engineers review the solution to ensure:

• All parts and accessories necessary for a complete working solution are included
• All components have been checked and verified to work together as a system
• The selected components will perform as required by the project specifications