Servo Motor Brakes

With over 140 models, seven bore sizes, and a variety of mounting configurations and torque offerings, Nexen Servo Motor Brakes make retrofitting on existing machines quick and easy. The brake flange replicates the servomotor flange so no accommodations are needed. Simply slide the brake between your motor and gearbox and tighten the shaft collar.

• Spring-engaged, air-released
• Zero backlash
• Long facing life
• Can be used in all orientations
• Low inertia
• Sizes to fit all servo motors
• Meets IP67 standards
• Emergency stopping and holding
• Enough torque to stall servo motor

When starting any new automation project, In-Position Technologies engineers start by reviewing the key requirements to determine all necessary components needed in an application. This includes providing recommendations for any appropriate controllers, power supplies, sensors, encoders, bearings, couplings, and any other components needed to fit the application. Our engineers perform all necessary engineering assessments to make sure all components perform properly together, are within customer specifications, and do not come with unnecessary costs.

This includes:

• Payload, reach, speed, cycle time, and repeatability requirement
• Specifying the appropriate feedback device (sensors, vision system, torque sensor)
• Verifying mounting compatibility, form factor checks, etc.
• Ensuring compatibility with the current system
• Ensuring all necessary auxiliary equipment are also specified

When ordering Servo Motor Brakes as a part of a full system, IP Tech engineers review the solution to ensure:

• All parts and fittings necessary for a complete working solution are included
• All components have been checked and verified to work together as a system
• The selected components will perform as required by the project specifications